PCB with SMDs

Konstruiert und fotografiert von Ad.
Hochgeladen am 3.3.2014, 11:03 von Ad.  3 / 7

I used hot air soldering which made a bit of a mess because it is difficult to apply the correct amount of paste. Also the Voltage regulator is missing because I didn’t have any left.

lemkajen (3.3.2014, 18:43:56)

Maybe its better to solder them on an konventionel way by soldering Iron - or with IR-oven. by hot air it’s to difficult to control the Temp in the right range.. but over all - nice project! :-) kind regards jens